Introducing the new Arbor Press from Derraco Engineering!
We looked around at what other products were in the market, and quickly realised we could produce one that not only exceeded them in terms of quality and function, but also at a much lower price point.
The Derraco Arbor Press is centred around a 300mm upright stem, allowing even the biggest of cartridges to be reloaded, and has been machined to incredibly tight tolerances to negate and slop. 
This upright stem also has a guide channel machined into it which matches up with a detent on the head of the press, allowing it to be lined up for consistent repetition.
The head contains 2 SKF bearings for ultimate smoothness, and can be configured for either left-handed or right-handed users. It is easily adjusted up and down for optimum position depending on the size of your die and preferred cam-over position of the seating arm and the anvil pressing surface has  even specially ground to ensure it is perfectly parallel to the baseplate. 
These components are all then fixed to a solid base plate with an XXL footprint so there is no risk of it tipping over during use, and comes with a snake-tongue guide piece which can be setup to guide the die to the same seating location time after time. No guesswork here.
Weighing in at nearly 3kg this press is not to be messed with and deserves prime place on your bench!
For a limited time these are available at just £100 so grab one whilst you can….